Ordering Options - Beckhoff AX8000 Series Operating Instructions Manual

Product overview

Ordering options

3.5
Multi-feedback interface
3.5.1
Drive-integrated safety
3.5.2
technology
24 ───
Ordering options are defined via the type key and must be ordered
separately. The listed components cannot be retrofitted.
The "multi-feedback interface", [Page 71] supports the digital feed-
back system EnDat 2.2 or BiSS-C.
There are two further D-Sub 15-pin connectors behind the front
cover of the axis module. Therefore, up to two EnDat 2.2 or BiSS-C
feedbacks can be connected with a single-axis module. With a dual-
axis module one feedback interface is assigned to each axis.
A servomotor from the AM8000 series with a G or H feedback sys-
tem according to the type key is absolutely necessary for the com-
missioning of the axis modules with integrated safety technology.
Prior to commissioning the axis modules with integrated safety
technology, read the original operating instructions:
"AM8000 & AM8500 Synchronous Servomotors"
Observe the TwinSAFE documentation
Before putting the axis module with integrated safety technology
into operation, read the documentation:
"AX8911 TwinSAFE drive option for servo drives from the AX8xxx-
xxxx series"
AX8000 Version: 1.1