Table of Contents
Advertisement
10. Using the V FOLD and H FOLD adjustment knobs on the fold mirror, bring the image back up
and fill the active light area.
11. Using the Rotate slider on the integrator, rotate the integrator to reduce shadows in the image.
12. Check the image quality.
13. As required to fill the image, make fine adjustments to the fold mirror, integrator rotation, and
integrator focus.
14. When the correct image quality is achieved, tighten all screws to hold the adjustments:
•
The two integrator lock screws on the integrator.
•
The Focus slider lock screw on the integrator.
•
The V FOLD and H FOLD screws on the fold mirror.
15. Re-install the top cover of the projector.
Aligning the boresight
The boresight adjustment balances the tilt of the lens mount to compensate for screen-to-projector
tilt.
Caution! If not avoided, the following could result in minor or moderate injury.
•
Do not look directly into the lens when the light source is on. The extremely high brightness can
cause permanent eye damage.
1. Display the boresight test pattern.
Cinema 2K-RGB Installation and Setup Guide–CP2415-RGB and CP2420-RGB
020-103259-01 Rev. 1 (10-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Adjusting the image
45
Advertisement
Table of Contents
