•
The two Rotate set screws on the integrator.
•
The Focus slider lock screw on the integrator.
•
The V FOLD and H FOLD screws on the fold mirror.
15. Reinstall the top lid of the projector.
Aligning the boresight
The boresight adjustment balances the tilt of the lens mount to compensate for screen-to-projector
tilt.
1. Display the boresight test pattern.
a) In the right toolbar, tap Test Patterns.
b) Select the RGB-2K-Boresight pattern and display it full screen.
2. Focus the image on cross-hair image I.
3. Evaluate the focus on cross-hair image II and III.
•
If all three images are in focus, no further action is required.
•
If boresight is required, continue to step 4.
The adjustment screws (A) on the lens mount affects the corresponding cross-hairs on the test
pattern.
CP2315-RGB Installation and Setup Guide
020-102772-02 Rev. 1 (05-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Adjusting the image
39