Configure The Sdp Payload Types; Configure The Sip Settings For Extensions - Cisco 6800 Series Administration Manual

Configure the SDP Payload Types

Procedure
Step 1
Select Voice > SIP.
Step 2 In the RTP Parameters section, set the Real-Time Transport Protocol (RTP) parameter values as described
in RTP Parameters, on page
Step 3 Click Submit All Changes.
Configure the SDP Payload Types
Configured dynamic payloads are used for outbound calls only when the Cisco IP Phone presents a Session
Description Protocol (SDP) offer. For inbound calls with an SDP offer, the phone follows the caller's assigned
dynamic payload type.
The Cisco IP Phone uses the configured codec names in outbound SDP. For incoming SDP with standard
payload types of 0-95, the phone ignores the codec names. For dynamic payload types, the phone identifies
the codec by the configured codec names (comparison is case-sensitive).
Before you begin
Access the phone administration web page. See
Procedure
Step 1
Select Voice > SIP.
Step 2 In the SDP Payload Types section, set the value as specified in
• AVT Dynamic Payload—Any nonstandard data. Both sender and receiver must agree on a number.
Step 3 Click Submit All Changes.

Configure the SIP Settings for Extensions

Before you begin
Access the phone administration web page. See
Procedure
Step 1
Select Voice > Ext(n), where n is an extension number.
Step 2 In the SIP Settings section, set the parameter values as described in
Step 3
Click Submit All Changes.
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
70
237.
Ranges from 96 to 127. Default: 101.
Access the Phone Web Page, on page
SDP Payload Types, on page
Access the Phone Web Page, on page
SIP Settings, on page
Phone Installation
92.
238.
92.
277.