Huawei UA5000 Manual page 93

UA5000 Universal Access Unit
Environment Monitoring
Table 7-5
Table 7-5 Mapping between the output tributary switches and the load tributaries
Output Tributary Switch
BATT.
LOAD1
LOAD2
LOAD3
LOAD4
DIP Switch
The EPS75-4815AF power system provides a DIP switch, the DIP switch is on the right middle
of the monitoring module control board, which can be seen after you remove the monitoring
module. The DIP switch has eight available electrical switches. ON indicates 1, and OFF
indicates 0.
Table 7-6 Settings of the DIP switch
Electrical
Switch
1-5
6-7
8
The DIP switchs 1-5 are used to set the address of the environment monitoring module,
7-7
Issue 01 (2012-08-17)
shows the mapping between the output tributary switches and the load tributaries.
Table 7-6 describes the settings of DIP switch.
Setting
Supported
Supported
Not
supported
shows the settings of the Dip switchs.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Load Tributary
BATT.(-) (two channels) and BATT.(+) (two channels)
LOAD1(-) (two channels) and LOAD1(+) (two
channels)
LOAD2(-) (two channels) and LOAD2(+) (two
channels)
LOAD3(-), LOAD3(+)
LOAD4(-), LOAD4(+)
Indication
Used to set the address of the environment
monitoring module.
Used to set the rate of the serial port
-
7 EPS75-4815AF Monitoring Solution
Factory
Default
1:OFF
2:OFF
3:OFF
4:OFF
5:OFF
6:ON
7:OFF
OFF
Table
87