Huawei UA5000 Manual page 145

UA5000 Universal Access Unit
Environment Monitoring
Monitoring
Parameter
Displayed
on the Host
Wiring alarm
Battery Tem
environment
Tem/
environment
Hum
Data Plan
Table 8-15
Table 8-14 Data plan for configuring the monitoring parameters of the ETP4890
Item
EMU
Charging
parameters
of the battery
Issue 01 (2012-08-17)
Device
Port
JTP1
VBTEM2
VTEM2
NOTE
Before adding a user-defined analog or monitoring digital parameter, make sure that the port corresponding
to this parameter is properly connected to an environment monitoring cable.
provides the data plan for configuring the monitoring parameters of the ETP4890.
Data Plan for the
F01D500 Cabinet
Type: POWER4875L
SN: 0
Subnode ID: 0
Charging mode of the
battery: automatic
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Application in Application in
the F01D200 the F01D500
Cabinet Cabinet
MDF MDF
Battery Battery
temperature temperature sensor
sensor
Temperature and Temperature and
humidity sensor humidity sensor
Remarks
During the configuration of the ETP4890, the type
of the ETP4890 is selected as POWER4875L.
-
The subnode ID must be the same as the subnode
setting of the corresponding DIP switches on the
EMU, but the subnode ID must be different from
IDs of the other subnodes on the same bus.
This parameter is set according to the actual
requirements.
automatic: The power system automatically
adjusts the charging mode of batteries according
to the status of the battery set.
equalizing: The battery is charged forcibly so as
to quickly compensate for the lost capacity of the
battery.
floating: The battery adjusts charging/
discharging when it is in saturation.
Default: automatic.
8 ETP4890 Monitoring Solution
Application in
the F01D1000
Cabinet
MDF
Battery
temperature sensor
Temperature and
humidity sensor
139