Huawei UA5000 Manual page 60

UA5000 Universal Access Unit
Environment Monitoring
Item
Digital
parameters
Configuration Process
The monitoring parameters can be reported to the control board only when the data of the ESCM
is correctly configured in the system.
5-9
Issue 01 (2012-08-17)
Data
Name of analog parameter
2: Humidity
Alarm ID of analog
parameter 2: 2
Unit of analog parameter 2:
% RH
Sensor type of analog
parameter 2: voltage type
Digital parameter ID: 0
Valid level of digital
parameter 0: high level
Digital parameter ID: 1
Valid level of digital
parameter 1: low level
Digital parameter ID: 9
Valid level of digital
parameter 9: low level
NOTE
The preceding data is configured according to the actual requirements. When the actually planned value
of a parameter is the same as the default value, it is not necessary to configure the parameter.
lists the commands used during the configuration.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Remarks
-
The user-defined humidity alarm of the
system is used.
-
-
The monitoring digital parameter of the
MDF sensor is set here to monitor the status
of the MDF. When the MDF is faulty, the
host reports an alarm.
Allocated by default (unable to be changed
by the user).
When the high level represents the valid
level, the host does not report an alarm in the
case of high level.
The monitoring digital parameter of the door
status sensor is set here to monitor the door
status. When the cabinet door is opened, the
host reports an alarm.
Allocated by default (unable to be changed
by the user).
When the low level represents the valid level,
the host does not report an alarm in the case
of low level.
The user-defined water monitoring analog
parameter is added.
When the low level represents the valid level,
the host does not report an alarm in the case
of low level.
Figure 5-5 shows the configuration process, and
5 ESCM Monitoring Solution
Table
54