Ko Propo EX-1 Mars Operation Manual page 83

Description 1
A
AC Charger
Alarm
B
Band Plate
Band
C
Computer (CPU)
Connector
Crystal
Center Trim
Channel
Click
Carburetor
Clutch
Cycle
D
DC Charger
Discharger
Delay
E
ESC Electric speed controller which controls the RPM of the motor for electric-powered models.
F
FET Servo The high class servo using FET transistor that increases the power output of the unit.
FM (Frequency modulation)
Frequency Range
Fridgity
G
Grommets
H
Hydropack
High Frequency ESC
L Linkage
LCD
LED
Mechanical Plate
M
Memory
Terminology used in radio control mode usage.
Please refer to the Index for the terminology or wording
of this transmitter.
Frequency of the crystals. Can be changed by replacing the cry
stals within a frequency
Central processor unit. the part of a computer which controls all other parts.
Interchangeable item which changes the frequency of the transmitter / receiver.
Even if the trim is adjusted, overall turning angle point will not be changed.
The air / fuel regulator that controls the speed of engine.
The mechanism that controls the engagement of the final drive.
The charger gets power supplied by 12V batteries or constant power supply unit.
The device which discharges the remaining energy from nicad batteries.
A method of encoding data by varying the frequency of a constant carrier.
The very small area where the servo does not respond to the stick movement.
Rubber materials to prevent the vibration of the servo. Attach them to the servo mounts.
Assembled rechargeable nickel metal battery pack with higher capacity than a nicad battery.
The speed controller that controls the motor with a fast cycle of
frequency. High efficiency and smooth control.
Light emitting diode. Type of diode that emits light when current pass through.
The plate where the servo or receiver is installed in the chassis.
The device that can hold data in machine readable format.
83
The charger gets power supplied by AC mains.
Audible warning sounds from the transmitter.
Plate which indicates current frequency.
range.
Detachable electric terminal unit.
The number allocated to each servo, etc.
The stopper that holds the trims in place.
A set of events in a regularly repeated order.
One of the wave bands i.e. 40Mhz, 27Mhz.
Joint mechanism between servo and the model.
Liquid crystal display.
Act slowly.