Ko Propo EX-1 Mars Operation Manual page 11

Tuning Screwdriver
•As shown in the diagram, push to the bottom of the small cov-
er with your finger to open. After removing the cover, turn it
around and put it back so that the turning screwdriver is taken
out.
•When putting the screwdriver back inside the compartment,
turn the grip upward to store. ( as shown in the illustration).
Otherwise, it will be difficult to open the cover again.
Trigger Bar Adjustment
•As shown in the illustration, use a Phillips screwdriver to loos-
en the screw located at the base of the trigger and adjust the
trigger bar to fit your finger.
•When fixing the trigger bar, be careful not to overtighten the
screw.
•If the trigger pad comes loose, glue it back in the place.
Replacing the Color Pad
Removing the Pad
Put your fingernail in the edge of the color pad and pull the pad
off.
Attaching the Pad
(1) Position the tabs on the pad so that they are in place, starting
from the bottom.
(2) Next, work your way up the handle, pushing the tabs into their
slots. If a particular tab does not go into its slot easily, use a
standard flat-tip screwdriver to push the tab in.
(3) Squeeze the grip so that the pad fits the shape of the handle.
Replacing the High-Frequency Module
and crystals.
•Replace the RF Module for changing the frequency range.
•Replace the crystals for changing the frequency. (band)
•Be sure to turn off the switch when changing the RF Mod-
ule or crystals.
•Insert the crystal properly.
Advice
Advice
The signals won't emit by taking off the RF
Module when you want to adjust the transmit-
ter during the race.
Warning!
When changing the crystals, be sure to use genuine
FM-type transceiver crystals by KO Propo. (both
transmitter and receiver) *Crystals by other manufac-
tures may operate at slightly different frequencies,
which results in loss of control.
Caution!
The former EX-1 RF Module cannot be used because
of the different tuning.
11
RF Module
Crystal