Ko Propo EX-1 Mars Operation Manual page 81

Notes on Installing the Receiver
The installation position should be as
far as possible from the motor, ESC,
nicad batteries, silicone wires or
other noise sources.
Especially, do not route the silicone
wires next to the receiver. (must not
be near to the crystal)
FET servo blue wire (7.2V wire) and
switches can also generate noise,
position them as far away as possible
from the receiver and the antenna.
Do not position the
receiver or the
antenna on the top
of the motor or the
nicad batteries.
When mounting the
receiver and
antenna on the
"upper deck",
position them as far
away from the
nicad batteries and
motor as possible.
Mounting the Receiver (Electric-powered car)
When fixing the receiver in place on the chassis or on the "mechanical
plate",
that the receiver is cushioned somewhat.
Do not mount the
receiver directly on
the chassis or
"mechanical deck"
Notes on Receiver Usage
use two pieces of double-sided tape,
Use two layers of
double-sided tape.
The silicone wire passes directly
over the receiver.
Do not allow the silicone wires to
cross the antenna.
Do not route the wires near the
antenna.
Do not position the antenna
opening or the crystal near the
nicad batteries, motor, or the
carbon chassis.
one on top of the other, as
Do not position the
crystals on the
bottom
81
Antenna
Always position the
crystal on the top