Ko Propo EX-1 Mars Operation Manual page 63

Set the Start Point of Pumping Effect. (ABS Position)
It is a waste of energy to apply the pumping effect to the servo in an
unnecessary range. Apply the pumping effect beyond the position
which you set up here.
Switch to the ABS position screen by the
Select key.
By the trigger operation, "Act" is dis-
played, which allows you to confirm that
this function is activated.
Use the +/- keys to adjust the value.
When this function is assigned to the Et,
it can be adjusted assuming the value
displayed on the screen as a maximum
value.
Advice
Advice
•In case of a gasoline-powered car, Start with a setting of around 60.
Set the Pumping Effect Cycle. (ABS Cycle)
Set the turn and return cycle of the servo.
Switch to the ABS cycle screen by the
Select key.
Use the +/- keys to adjust the value.
When this function is assigned to the Et,
it can be adjusted assuming the value
displayed on the screen as a maximum
value.
Warning!
Do not set the cycle unnecessarily quick.
*The large current to the servo may result in
the model running out of control.
Advice
Advice
•Please try a setting of around 98 in case of a
gasoline- powered car, although it is different
depending on the servos.
•When you are using a Fail Safe Adapter it is usual
that the monitor lamp may blink, If you set the
function to a quick cycle.
63