Ko Propo EX-1 Mars Operation Manual page 36

Time the lap time (Lap Time)
Each lap time can be stored like an auto lap counter used in an actual
race.
Alarm indicating the passage of time sounds every minute.
Set TIM1 to BT1 or 2 on the Set up
Screen (p46)
First, set the alarm time (race time).
Switch to the Lap Time screen by the Se-
lect key, and then press both the +/- keys
simultaneously to enable the auto Start
function. (READY flashes on and off)
The timer starts when pulling the trig-
ger. Press the button each time a lap
is completed in order to count laps.
At the end of the race, the alarm
sounds. The timer then stops by the
button operation, and the race results
are displayed.
The timer can be paused by pressing
the Select key and to restart the timer,
press the Select key again.
Caution!
•The lap count shows up to 99 laps, however the lap record will consist of the last 40 laps.
•The memory of each lap will be stored from the number of laps displayed in the Lap
Review screen.
•The goal time of the race is stored in the next lap after the final lap.
•The minimum interval is 3 seconds. It cannot be input for less then 3 seconds. During the
timing, lap time indication will be held for 3 seconds when the button is in operation.
Advice
Advice
•When READY is blinking or pausing the timer, settings on other screens can be
changed.
•Can be used without alarm setting. In this case, press the +/- keys simultaneously to
reset, which stops the timer.
36
Button1