Ko Propo EX-1 Mars Operation Manual page 79

Be certain to use only KO Propo
Warning!
genuine FM crystal sets(transmitter
and receiver). Never use crystals
produced by other companies since
such crystals may vary in frequency,
which could lead to misoperation or
out of control
Be sure to connect all equipment
Warning!
correctly. If connections are loosened
by vibration,the model may run out of
control.
Do not cut or bundle the aerial wire
Warning!
with other cords. It may result in
decreasing the sensitivity of the
receiver and may result in the model
running out of control.
Be careful not to reverse the polarity
Caution!
of the transmitter and the receiver.
Reverse polarity could damage the
units.
Be sure to use genuine KO Propo
Caution!
products e.g. transmitter,receiver,
ESC and other optional parts.
* We cannot assume any
responsibility for the use of other
companies products with this unit.
Be sure to use grommets and be
Warning!
sure that the servo is not touching
any metal plates directly. * The
vibrations may damage the servo and
the model may run out of control.
Connecting the Receiver
Connecting
the receiver
Antenna Lead
BATT
Switch Harness
CH1
Steering Servo
For an electric-powered car (FET servo + FET
Receiver
Electric
Speed Controler
For a gasoline-powered car (6V FET servos)
5N600mAh
6VNicd Battery
Receiver
For a gasoline-powered car (7.2V FET Servos)
6N600mAh
7.2VNicd Battery
7V Reguletor
Switch Harness
Receiver
79
Crystal
replacement
CH2
ESC or Throttle Servo
Steering Servo
7.2V FET Servo
Switch Harness
Throttle Servo
Steering Servo
Throttle
Servo
Steering
Servo