Ko Propo EX-1 Mars Operation Manual page 24

Adjusting brake direction of the throttle servo turning angle.
Adjust the servo turning angle when moving
the trigger fully to the brake direction.
After switching the power on, press the
Up key until the Throttle Brake screen is
called up from the Initial Screen.
Use the +/- keys to adjust the maximum
turning angle.
The maximum value adjusted by
the Et Dial is fixed with the value of
this screen.
Current value of the dial can be
seen by pressing the Select key.
Advice
Advice
•The Custom keys can be set to Et. (Set Up
P42,43)
•When the unit is shipped from the factory,
the Brake is assigned to the Et 4.
•Be sure to set the Brake lever of the Et at
a maximum value before adjusting the
linkage.
Warning!
Be sure to check that there are no unnec-
essary force on the push rod by moving
the trigger fully after adjusting the linkage.
*It may damage the servo, and the model
run out of control.
24
(Throttle Brake)
ET4