Ko Propo EX-1 Mars Operation Manual page 42

Changing the function of Et Lever, Custom Key and Button.
On this screen;
Change part of Et lever or dial.
Set up the function to the Custom key for immediate call up.
Assign ON/OFF switch of timer or other functions to the button.
The three settings as mentioned above can be set up.
Change part of Et lever. (Set Up)
Can select the item in which values
are adjusted by the Et lever or Dial.
After switching the power on, enter the Sys-
tem Mode from the Initial Screen.
Press the Up key until the Set Up screen is
displayed.
Use the Select key to select the Et1~5.
Use the +/- keys to set each item. The items
assigned to the Et will blink and if you con-
tinue to select, previous items will be set to
OFF.
Et Setting Table
STrm
TTrm
TRAV
BRAK
THsp
TspL
TspM
TspH
AB.W
AB.P
AB.C
Ac.W
Ac.C
BTN
Note :
If setting BTN (Button) to Et lever, you can operate BT1 and 2.
System Level Possible to set Et Name
1
1
1
1
2 only
3
4
4
3
3
3
4
4
2
42
ET1
ET2
ET3
1.3.4 Steering Trim (P9)
2.4 Throttle Trim (P9)
2.3.4 Steering Travel (P21)
2.3.4 Throttle Brake (P24)
2.3.4 Throttle Speed (P40)
2.3.4 Throttle Speed Low (P60.74)
2.3.4 Throttle Speed Middle (P74)
2.3.4 Throttle Speed High (P60.74)
2.3.4 ABS Width (P62)
2.3.4 ABS Position (P63)
2.3.4 ABS Cycle (P63)
3.4 ACC Width (P76)
3.4 ACC Cycle (P78)
1.2.4 Button (note)
(Set Up Function)
ET4