Remotely Connect To Hpe Oneview; Configure Network Time Protocol; Add Ip And Subnet Address Ranges; Configure The Hardware In Hpe Oneview - HPE Synergy 12000 Frame Setup And Installation Manual

7. Unmanaged interconnect modules require console access for initial setup. Click the Actions menu on the top bar of
the HPE Synergy Console and select the module from the Serial Consoles > Interconnects menu.
a. Press the Enter key to begin the serial console session with that interconnect module.
b. Configure the interconnect module using the instructions provided with the interconnect module.
c. To close the session, click the X in the top right corner.
NOTE: To access the serial console for an interconnect module, connect to the HPE Synergy Console through ports in
the same frame as the interconnect module.
For more information, see the procedures for connecting to the HPE Synergy Console.
8. Log out from the HPE OneView Hardware Setup session.
To close the session, click the X in the top right corner of the Synergy console.
After hardware setup is complete, the system is ready to be configured for a production environment. An HPE
OneView administrator can perform configuration tasks with an account that provides additional user privileges.
For more information about HPE OneView administration, see the HPE OneView online help or the HPE OneView User
Guide for Synergy.

Remotely connect to HPE OneView

After Hardware Setup is complete, you can log in to HPE OneView remotely to complete configuration.
• IP Address: Use the Link-Local IP Address on the HPE Synergy Console.
Username: Administrator
•
Password (default): admin
•

Configure Network Time Protocol

Enter the IP address of one or more network time servers (NTP).
In a clustered appliance, both the active appliance and the standby appliance must be able to receive updates from the
time server. If the time server cannot reach the appliance, updating the time does not occur and the appliance generates
an alert.
To add NTP servers, go to OneView > SETTINGS > Time and Local.

Add IP and subnet address ranges

Enter IPv4 address requirements for management network connection to HPE iLOs and interconnects. If present in the
HPE Synergy network, add HPE Synergy Image Streamer IPv4 addresses.
For more information, see "About configuring IP addresses in an enclosure group" and "About ID pools" in the HPE
OneView Help for HPE Synergy.
To add IP Address ranges, go to OneView > SETTINGS > Edit Addresses and Identifiers > Edit.

Configure the hardware in HPE OneView

The steps in this section provide an overview of the initial setup of HPE OneView.
94 Configuring HPE Synergy