Run Hardware Setup - HPE Synergy 12000 Frame Setup And Installation Manual

Item
10
11
12

Run hardware setup

Procedure
1. From the HPE Synergy Console, click Connect to start HPE OneView.
2. To connect with install technician user privileges, click Hardware Setup.
To connect as Administrator, select the Administrator access check box.
3. Review the hardware inventory:
NOTE: A spinning icon at the top of the inventory section indicates when HPE OneView is bringing the enclosures and
the devices within them under management. Devices might not be listed until the discovery process is complete.
a. Wait for HPE OneView to complete the add operation.
b. Confirm that the inventory includes all installed components.
c. For any hardware not discovered by HPE OneView, look for problems with frame link module cabling, hardware not
fully inserted, or other hardware issues.
4. Review and correct any issues listed in the Hardware Setup Checklist:
a. To troubleshoot all issues, follow corrective actions in HPE OneView.
b. Return to the Hardware Setup screen and look for additional issues until the Checklist indicates Setup complete.
For more information about using HPE OneView, see the online help by clicking the question mark on the top bar of
the HPE Synergy Console.
5. (Optional) Select Edit networking from the Hardware Setup screen.
Edit the HPE OneView networking settings and click OK. The Maintenance IP address fields are required unless you
have disabled service console access.
6. To add a remote enclosure, select Actions > Add remote enclosures from the Hardware Setup screen.
Enter the IPv6 address of a frame link module that is connected to a frame in the remote frame link topology. The
remote frame link topology must be in the same subnet as the primary frame link topology.
Description
Frame front view - Displays the components installed in the front of the frame
and the health status of each component. Each component can be clicked to
view individual component health and information screens.
Health status include:
• Green: OK
• Yellow: Warning
• Red: Critical
Actions menu - Provides access to management and diagnostic actions.
Help screen - Provides a description of the HPE Synergy Console icons and
access to the frame link module end-user license agreement.
Configuring HPE Synergy 93