Hpe Synergy Console Connections - HPE Synergy 12000 Frame Setup And Installation Manual

Update the firmware on page 96
Run hardware setup on page 93
Connecting to the HPE Synergy Console using a laptop computer on page 88
Connecting to the HPE Synergy Console using a keyboard, video monitor, and mouse on page 89
Configure the hardware in HPE OneView on page 94
Configuring HPE Synergy Image Streamer on page 96
HPE Synergy Console Frame Health & Inventory screen on page 90
HPE Synergy Cabling on page 86

HPE Synergy Console connections

Connecting to the HPE Synergy Console using a laptop computer
WARNING: Do not plug the front panel laptop port into a switch. The front panel laptop port is designed to provide
a single laptop access to the HPE Synergy Console. Plugging the laptop port into a switch may cause issues on a
network where DHCP is running.
Prerequisites
At least one frame link module is installed in one of the frame link module bays.
Procedure
1. Ensure that the Ethernet port of the laptop computer is configured for DHCP.
Alternatively, you can configure the laptop computer Ethernet port to the IP address: 192.168.10.2 with the subnet
mask 255.255.255.0.
2. Use a CAT5 cable to connect the laptop computer Ethernet port to the laptop port on a front panel module.
3. Wait for the laptop computer to be assigned an IP address from the frame link module.
4. Access the HPE Synergy Console using either a VNC client or web browser:
• Web browser: Open a web browser and enter http://192.168.10.1.
88 Configuring HPE Synergy