Installation; Installing The Synergy System Components; Removing Components From The Frame - HPE Synergy 12000 Frame Setup And Installation Manual

Installation

Installing the Synergy system components

Procedure
1. Unpack the system.
2. Remove components from the frame.
3. For rack-free installations, set up the frame on an appropriate surface, and then install the frame options.
4. For rack installations, install the frame into the rack, and then install the frame options.
5. Install the frame components into the frame.
6. Connect the frame components in the frame.
7. Connect the AC power cables and power up the frame.
8. Configure the frame using the Composer.

Removing components from the frame

Before installing the frame into the rack, you must remove all of the pre-installed components from the front and rear of
the frame. Because a fully-populated frame can weigh up to 249.50 kg ( 550.00 lb), removing the components from the
frame makes moving and installing the frame easier.
With the frame still on the pallet, remove all components from the front and rear of the frame.
IMPORTANT: To ensure the correct configuration when installing components, be sure to note the location of each
component before removing it from the frame.
46 Installation