Choosing A Line For Autodial; Using Intercom As The Line For Autodial - Nortel Modular ICS 6.0 Manual

80 / Time savers for making calls

Choosing a line for Autodial

To include a line selection for an external number, press the
line or intercom button before you enter the number. To select
a line pool, press a programmed line pool button, or press the
button labelled Intercom and enter a line pool access code.
If you select a line before pressing the autodial button, the call
goes out on the line you have selected instead of the line that
is part of the autodialer programming.
For the M7100 and T7100 sets, an external autodialer can be
programmed only by using a line and not a line pool.
Tip -
number, the call uses your prime line (if you have one).

Using intercom as the line for Autodial

If you press the button labelled Intercom as the line for an
external autodial number, you must include a valid line pool
access code or a destination code. If line pool access codes or
destination codes are changed, remember to reprogram
autodial numbers.
Displays
987___
QUIT
Autodial full
Button erased
Modular ICS 6.0 System Coordinator Guide
If you do not include a line selection in an autodial
Continue to enter digits until the number is
BKSP OK
complete. Press
erase an incorrect digit. Press
when you are finished.
The memory allotted to autodial numbers in
your Norstar system is full.
While programming external Autodial, you
erased the button by pressing
before entering any digits.
Ã
BKSP
or
³
³
to
or OK
or OK
P0992640 03