Turning On Line Redirection - Nortel Modular ICS 6.0 Manual

110 / Forwarding your calls
You cannot use the Line Redirection feature on an M7100 or
a T7100 set, or on a telephone connected to an ATA.

Turning on Line Redirection

Follow these steps to turn on Line Redirection on your set:
² ¡ Ý
1. Press
2. Select the outgoing line to be used for redirected calls.
3. Enter the number to which calls are redirected.
Refer to the list below for suggestions.
4. Select the lines to be redirected.
In step 3, you can enter the telephone number to which you
want to redirect calls, using one of the following methods:
• Press an external autodial button.
• Enter an external telephone number (using no more than
24 digits) then press
³
• Press
outgoing line is a private network line that does not require
you to dial digits.
If you use ALL to redirect all your lines, it is important that you
wait until all the lines on your telephone light up before
³
pressing
light up, those lines not lit are not redirected.
Tip -
used normally when it is not busy on a redirected call. To avoid
redirection failing because the chosen line is in use, choose a
line pool with several lines in it.
Modular ICS 6.0 System Coordinator Guide
.
³
or OK if the line you have chosen as the
or OK. If you press
The line chosen for redirecting calls on other lines can be
or OK.
³
or OK before all the lines
P0992640 03