Autodial Programming Activation (P60, P61); Display Parameters Activation (P62) - Nortel Meridian SL-100 Reference Manual

2

Autodial programming activation (P60, P61)

Procedure 7-25 describes the steps required to activate automatic dial
(autodial) programming.
Note: The P in the following procedure represents the Program key.
Procedure 7-25
Activating autodial programming
1
2
3
4
5

Display parameters activation (P62)

Procedure 7-26 describes the steps required to activate display parameters.
The display scrolls through use of the volume control key on the phone. The
display shows those parameters of the MCA that can be modified through
keypad dialing.
Note: The P in the following procedure represents the Program key.
Procedure 7-26
Activating display parameters
1
Meridian SuperNode MSL-100 Meridian Modular Telephones Reference Manual MSL11
Press P59 to turn RTS on (no flow control).
Press P60 to activate automatic dial programming.
Response:
The set is in autodial programming and displays the following:
ADIAL XXXX
ENTER DIGITS, THEN P
Enter xxxP (the autodial number).
Press P61 to activate automatic call.
Response:
The set is in data monitor mode and displays the following:
ADIAL XXXX
DATA CALL CONNECTED
Press P to save and exit either command.
Response:
The set exits the programming mode.
You have completed this procedure.
Press P62 to activate the display parameters.
Response:
The display screen appears.
Keypad dialing 7-19