Assigning Or Unassigning Lines To A Group - Nortel Modular ICS 6.0 Manual

Assigning or unassigning lines to a group

Configure the prime set for a Hunt Group line to None to avoid
delayed ring transfer of external Hunt Group calls to the prime
set before the Hunt Group can receive the call.
A line can be assigned to only one group.
1. Place the appropriate programming overlay on the set you
are using to do programming.
² ¥ ¥ Û ß ß Ü Ý Ý
2. Press
display shows Password:.
Û Ü ß Ý ß
3. Press
Terminals&Sets.
4. Press ' until the display shows System
prgrming.
5. Press ≠. The display shows Hunt groups.
6. Press ≠. The display shows Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press ≠. The display shows Member DNs:.
9. Press '. The display shows Line assignment.
10. Press ≠. The display shows Show line:.
11. Enter the line number you want to program or press SCAN
to go to the first line assigned to this group, or press LIST
to go to the first line in the system.
12. Press CHANGE to program the line as Unassigned or
Assigned.
*HGnn* means the line is assigned to another Hunt Group.
¨
13. Press
P0992640 03
(ADMIN). The display shows
to exit or ' to continue programming.
Programming Hunt Groups / 165
(CONFIG). The
Modular ICS 6.0 System Coordinator Guide