Assigning A Distinctive Ring Pattern To A Hunt Group - Nortel Modular ICS 6.0 Manual

166 / Programming Hunt Groups

Assigning a distinctive ring pattern to a Hunt Group

You can assign distinctive ring patterns to your Hunt Group so
that calls can be rated in priority for the group. These
distinctive ring patterns, have the same characteristics as for
line and extension distinctive ring patterns.
The Hunt Group distinctive ring pattern determines how a call
will ring within the Hunt Group. If members of the group have
ring patterns assigned to their telephones that are higher than
the ring patterns of the incoming line or the Hunt Group, then
the Hunt Group will use the ring of the corresponding member
telephones.
If the incoming call (line) has a higher ring pattern assigned,
than the Hunt Group, the Hunt Group will ring with the line
ring pattern.
1. Place the programming overlay over the appropriate keys
on your programming telephone.
² ¥ ¥ Û ß ß Ü Ý Ý
2. Press
display shows Password:.
Û ß ß Ü Ý Ý
3. Press
Terminals&Extns.
4. Press ' until the display shows System
prgrming.
5. Press ≠. The display shows Hunt groups.
6. Press ≠ until the display shows Member extns:.
7. Press ' until the display shows Dstnct
Ring:NONE.
8. Press CHANGE to toggle to the ring pattern number you
want to assign to the Hunt group line. (None, 2, 3, 4)
¨
9. Press
Modular ICS 6.0 System Coordinator Guide
to exit or ' to continue programming.
(CONFIG). The
(CONFIG). The display shows
P0992640 03