Adding Or Removing Members From A Group - Nortel Modular ICS 6.0 Manual

Adding or removing members from a group

Members of the group can be any Norstar or Business Series
Terminal set, ISDN terminal, or portables. A Norstar set can
be in more than one Hunt Group but is considered a member
in each Hunt Group, increasing the total number of members
in the system.
There can be only one appearance of the same Hunt Group on
a set. Hunt Group DNs cannot be members of other Hunt
Groups. A DN can be associated with a member of a Hunt
Group and is called a member DN.
Consult your customer service representative to determine
your Hunt Group number range.
1. Place the appropriate programming overlay on your
programming set.
² ¥ ¥ Û ß ß Ü Ý Ý
2. Press
display shows Password:.
Û Ü ß Ý ß
3. Press
Terminals&Sets.
4. Press ' until the display shows System
prgrming.
5. Press ≠. The display shows Hunt groups.
6. Press ≠. The display shows Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press ≠. The display shows Member DNs:. (There
are no member DNs if none are programmed.)
9. Press ≠. The display shows the group members.
10. Press ADD to add a member or press REMOVE to remove a
member from the group.
¨
11. Press
P0992640 03
(ADMIN). The display shows
to exit or ' to continue programming.
Programming Hunt Groups / 163
(CONFIG). The
Modular ICS 6.0 System Coordinator Guide