Changing User Speed Dial - Nortel Modular ICS 6.0 Manual

Use the display buttons to change the programming for a
button.
Note: User Preferences programming cannot change the
buttons that are used by lines, intercom, and the handsfree
feature.
The display buttons used in button programming.
CANCL
CLR
TEL#
CHANGE
FEATR
FIND
LIST

Changing User Speed Dial

1. Press ≠ at User Speed Dial. The display shows
the number of speed dial codes that are available.
2. Press ' to see the first speed dial code (256).
3. Press ' to move through all the speed dial codes.
4. Press ≠ to find the code you want to change.
P0992640 03
Moves you out of a setting without making any changes to
it.
Erases the button.
Programs the key as an autodial number for an internal or
an external number. If it is an external autodial number, you
must choose a line, line pool, or the routing table for the call
to use.
Used when you are setting up an external autodial number.
CHANGE
Press until you see the type of line or pool you
want the number to use.
Press to store a feature code on the button.
Locates a specific button on a telephone by entering its
number. Button numbers are shown in the illustrations.
Takes you to a list of feature codes. Press
move through the list and press
feature you want to program on the button.
User Preferences / 157
'
OK
when you see the
Modular ICS 6.0 System Coordinator Guide
to