Remote Control Via Gpib - Rigol DG2052 User Manual

RIGOL

Remote Control via GPIB

1. Connect the device
Connect the generator to your computer by using a USB-GPIB interface
converter.
Note: Please make sure that a GPIB card has been installed to your PC. Connect
the USB terminal of the USB-GPIB interface converter to the USB HOST interface
on the rear panel of the generator. Connect its GPIB terminal to the GPIB card
terminal of the PC.
2. Install the driver of GPIB card
Correctly install the driver of the GPIB card which has been connected to the PC.
3. Set the GPIB address
When the Shift key is illuminated, press Pulse/Utility → Interface → GPIB
set the GPIB address of the generator.
4. Search for the device resource
Start up the Ultra Sigma and click
search panel as shown in figure (a). Click "Search" and the software will search
the GPIB instrument resources connected to the PC. The device resources found
will be displayed on the right side of the panel as shown in figure (b). Click "OK"
to add the resource.
3-4
to open the GPIB resource
(a)
Chapter 3 Remote Control
DG2000 User Guide