Safety Measures At The Setup Location And During Transport; Safety Measures In Normal Operation - Fronius TPS/i Robotics TWIN Push Operating Instructions Manual

Shielding gas is colorless and odorless and may suppress the oxygen in the ambient air in
the event of leakage.
-
-
-
-
Safety Measures A toppling device can be deadly! Set up the device securely on an even, solid surface
at the Setup Loca- -
tion and During
Special regulations apply in areas at risk of fire or explosion
Transport
-
Use instructions and checks within the company to ensure that the vicinity of the workplace
is always clean and organized.
Only set up and operate the device in accordance with the protection class shown on the
rating plate.
When setting up the device, ensure that there is an all-round clearance of 0.5 m (1 ft.
7.69 in.) to allow cooling air to circulate unhindered.
Take care to ensure that the applicable national and regional guidelines and accident pre-
vention regulations are observed when transporting the device, especially guidelines con-
cerning hazards during transport and shipment.
Do not lift or transport any active devices. Switch off devices before transport or lifting.
Before transporting the device, completely drain the coolant and dismantle the following
components:
-
-
-
It is essential to conduct a visual inspection of the device to check for damage after it has
been transported but before commissioning. Have any damage repaired by trained service
technicians before commissioning the device.
Safety Measures Only operate the device when all safety devices are fully functional. If the safety devices
in Normal Opera- are not fully functional, there is a danger of:
tion -
-
-
Safety devices that are not fully functional must be repaired before the device is switched
on.
Never bypass or disable safety devices.
Before switching on the device, ensure that no one can be put in danger.
The device must be examined at least once a week for externally detectable damage and
functionality of the safety devices.
Always secure the shielding gas cylinder well and remove before transporting by crane.
Ensure there is a sufficient supply of fresh air with a ventilation flow rate of at least
20 m³ per hour.
Please observe the safety and maintenance information for the shielding gas cylinder
or the main gas supply.
When no welding is taking place, close the valve of the shielding gas cylinder or the
main gas supply.
Always check the shielding gas cylinder or main gas supply for uncontrolled gas leak-
age before each start-up.
The maximum permitted tilt angle is 10°.
Follow the appropriate national and international regulations.
wirefeeder
wirespool
shielding gas cylinder
Injury or death to the operator or a third party
Damage to the device and other material assets belonging to the operating company
Inefficient operation of the device
15