Safety Measures At The Setup Location And During Transport; Safety Measures In Normal Operation; Maintenance And Repair; Safety Symbols - Fronius Virtual Welding 2.0 Operating Instructions Manual

Safety measures Take care to ensure that the applicable national and regional guidelines and acci-
at the setup loc-
dent prevention regulations are observed when transporting the device. espe-
ation and during cially guidelines concerning hazards during transport and shipment.
transport
Only carry out the transport in the original packaging. The original packaging is
available from the manufacturer.
Do not lift or transport any active devices. Switch off devices before transport or
lifting.
Carry out internal instructions and checks to ensure that the vicinity of the work-
place is always clean and organized.
After transport and before installation and commissioning, it is essential to visu-
ally inspect the device for damage. Have a trained service technician repair any
damage before installation and commissioning.
Safety measures Only operate the device when all safety devices are fully functional. If the safety
in normal opera- devices are not fully functional, there is a danger of:
tion
-
-
-
Safety devices that are not fully functional must be repaired before the device is
switched on.
Never bypass or disable safety devices.
Before switching on the device, ensure that no one can be put in danger.
The device must be examined at least once a week for externally detectable dam-
age and functionality of the safety devices.
Maintenance and It is impossible to guarantee that bought-in parts are designed and manufac-
repair tured to meet the demands made of them, or that they satisfy safety require-
ments.
-
-
-
-
The housing screws provide the ground conductor connection for earthing the
housing parts.
Only use original housing screws in the correct number and tightened to the spe-
cified torque.

Safety symbols

Devices with the CE label satisfy the essential requirements of the low-voltage
and electromagnetic compatibility directive (e.g., relevant product standards of
the EN 60974 series).
10
Serious or fatal injury to the operator or third parties
Damage to the device and other material assets belonging to the operating
company
Inefficient operation of the device
Use only original spare and wearing parts (also applies to standard parts).
Do not carry out any modifications, alterations, etc. to the device without the
manufacturer's consent.
Components that are not in perfect condition must be replaced immediately.
When ordering, please give the exact designation and part number as shown
in the spare parts list, as well as the serial number of your device.