Emf Measures; Safety Measures At The Setup Location And During Transport; Safety Measures In Normal Operation - Fronius Robacta Reamer V Comfort Operating Instructions Manual

Supporting measures to avoid EMC problems:
1.
2.
3.
4.

EMF measures

Electromagnetic fields may cause health problems that are not yet known:
-
-
-
-
Safety Measures A toppling device can be deadly! Install the device horizontally on a flat, stable
at the Setup surface free of vibration, anchor it securely on the surface, and secure against
Location and
toppling.
during Transport
Special regulations apply in areas at risk of fire or explosion
-
Use instructions and checks within the company to ensure that the vicinity of the
workplace is always clean and organized.
Take care to ensure that the applicable national and regional guidelines and acci-
dent prevention regulations are observed when transporting the device, espe-
cially guidelines concerning hazards during transport and shipment.
It is essential to conduct a visual inspection of the device to check for damage
after it has been transported but before it is commissioned. Have any damage re-
paired by trained service technicians before commissioning the device.
Safety Measures Only operate the device when all safety devices are fully functional. If the safety
in Normal Oper- devices are not fully functional, there is a risk of
ation -
-
-
Safety devices that are not fully functional must be repaired before the device is
started up.
Never bypass or disable safety devices.
Before starting up the device, ensure that no one can be put in danger.
8
Grid power supply
- If electromagnetic interference occurs despite a grid connection that
complies with regulations, take additional measures (e.g., use a suitable
grid filter).
Control lines
- Keep them as short as possible
- Route them close together (also to avoid EMF problems)
- Route them far from other lines
Equipotential bonding
Shield, if necessary
- Shield other devices in the vicinity
- Shield the entire welding installation
Effects on the health of persons close by, e.g., those with pacemakers and
hearing aids
Persons with pacemakers must seek advice from their doctor before staying
in the immediate vicinity of the device and the welding process
Keep distances between welding power-leads and the head/torso of the
welder as great as possible for safety reasons
Do not carry welding power-leads and hosepacks over your shoulder or wrap
them around your body or body parts
Follow the appropriate national and international regulations.
injury or death to the operator or a third party,
damage to the device and other material assets belonging to the operating
company,
inefficient operation of the device.