Serial Interface Module - HPE FlexNetwork MSR Series Manual

Compared with ADSL, G.SHDSL allows longer transmission distance and has a wider application
scope. It is an alternative to E1/T1 line for high-speed data service access. However, because
TCPAM uses the band starting from 0 Hz for data transmission, G.SHDSL cannot share the same
line with POTS or ISDN.
The MIM-1SHL-4W provides the following features:
•
Manual G.SHDSL line activation/deactivation and easy-to-use fault location tools.
•
G.991.2 interface standard and auto-sensing.
•
Allows you to set the dual-pair G.SHDSL interface to operate in dual-pair or single-pair mode.
Interface specifications
Table 101 Interface specifications
Item
Connector
Number of connectors
Interface standard
Interface rate
Interface cable
Supported services
Interface LEDs
Figure 70 MIM-1SHL-4W panel
Table 102 LED description
LED
LINK
ACT
Interface cables and connection methods
For more information about G.SHDSL interface cables and connection methods, see
interface."

Serial interface module

•
MIM-2SAE
Specification
RJ-11
1
ITU-T G991.2
ITU-T G994.1 handshaking
In single-pair mode, supports the sending and receiving independent
symmetric rates in the range from 192 kbps to 2312 kbps in steps of 8
kbps.
In dual-pair mode, supports the sending/receiving independent
symmetric rates in the range from 384 kbps to 4624 kbps in steps of 16
kbps.
Tailor-made 4-wire telephone cable
G.SHDSL access over ordinary telephone lines
Description
•
Off means no link is present.
•
On means a link is present.
•
Off means no data is being transmitted or received.
•
Flashing means data is being received or transmitted.
65
"G.SHDSL