Ricoh Beluga-C1 Training page 98

Data Overwrite Security Unit
Must be type H
Make sure that you have a type H unit.
Before you can install this unit, the customer must
store some names and passwords related to
authentication.
Check the box to make sure that the VOID marks
are not visible on the packing tape.
Enable the unit with SP 5878 001.
» If you have installed the wrong type by mistake, you will
see 'Failed' on the display when you do this SP. Do the
installation procedure again with the correct type of
DOS unit.
» You do not have to replace the NVRAM
Follow the procedure in the service manual
carefully, or the installation will fail.
Slide 98
VOID marks: If these are visible, it is possible that the box has been tampered
with, and security could be compromised.
98
Beluga-C1/C1.5 Training