Ricoh Beluga-C1 Training page 188

Replacement and Adjustment
Developer
You need one unopened toner cartridge to do this
procedure (or, you can tape up the existing cartridge, so
that toner cannot get out).
The installation procedure for new developer is similar to
the steps in the machine installation procedure for installing
developer and toner.
» Set a new toner cartridge after you add the first bag of
developer (do not remove the tape).
» Then turn the power on to distribute the first bag. (This takes
about 22 seconds).
» Turn the operation switch off, then turn the main power switch
off.
» Then remove the toner cartridge and add the second bag.
» Then install a toner cartridge and remove the tape (you can
use the old toner cartridge if toner is remaining).
» Input lot numbers and initialize the developer.
Slide 188
Make sure that you are aware of the SP modes that must be done after each
procedure (they are in the procedures in the manual).
188
Beluga-C1/C1.5 Training