Ricoh Beluga-C1 Training page 69

Testing the Breaker Switch
The machine power must be off.
The power cord must be connected to the power source.
Test the breaker switch.
Push the button with the screwdriver until the 'O' appears.
Then manually turn the switch to the 'I' position.
This switch must be tested once a year.
Slide 69
If the breaker switch does not drop to the "O" position:
Make sure that the power cord is securely connected to the power supply.
Push the test button again.
If the breaker switch does not snap down to the 'O' position, the breaker
switch must be replaced.
The breaker switch must be at the "I" position for the machine to operate.
69
Beluga-C1/C1.5 Training