Ricoh Beluga-C1 Training page 203

What Happens when Roll End is Detected
If the roll has a black core
Slide 203
No additional notes
When a roll end sensor signals roll end after the
trailing edge of the white paper separates from
the black core:
» If less than 210 mm (about 8 in.) has fed past the cutting
sensor, the paper roll reverses and takes up 200 mm of
paper. The paper does not exit the machine.
» If more than 210 mm has fed past the cutting sensor,
paper feed stops the cutter cuts the paper, the paper roll
reverses and takes up the paper. There is no slack in
the paper, so the paper is cut diagonally. This is no
problem for plain paper and translucent paper, but with
film the machine will signal a jam.
203
Beluga-C1/C1.5 Training