Ricoh Beluga-C1 Training page 200

Sensors in the Vertical Feed Path
Cutting Sensor (Roll 1)
Roll 1 Lead
Edge Sensor
Roll 2 Lead
Edge Sensor
Slide 200
The cutter cuts the paper after the specified paper length has been fed.
The amount of paper fed is monitored by the cutting sensor.
The starting time of the cutter depends on the cutting mode selected at the
operation panel (preset cut, synchro cut, or variable cut)
After paper has been cut, the roll must be reversed to a standby position away
from the cutter. This allows the next job to go ahead quickly, if another roll is
chosen.
For each tray, there is a sensor called the lead edge sensor. This detects
when the paper has been reversed away from the cutter.
200
Beluga-C1/C1.5 Training