Ricoh Beluga-C1 Training page 34

This new feature allows you to send print data files to an
SD card in the service slot (slot 2 in this machine).
Card Save mode must be turned on with printer bit switch
1, bit 4.
Files are stored on the SD card in the folder /prt/cardsave.
Card Save cannot be used with PJL Status Readback
commands.
Slide 34
No additional notes
Card Save (1)
The data is not printed.
Card Save will remain enabled until the SD card becomes
full, or until all file names have been used.
File names are assigned sequentially from PRT00000.prn
to PRT99999.prn.
An additional file PRT.CTL will be created. This file contains
a list of all files created on the card by the card save
function.
34
Beluga-C1/C1.5 Training