Ricoh Beluga-C1 Training page 152

Cleaning Blade Release
Slide 152
Before doing the Drum Set Mode procedure, move the cleaning blade lever to
the left (as seen from the front of the machine) to make sure that the blade is
away from the drum.
The diagram on this page is a side view. The three-dimensional view at the
top right is a rear view, so the handle moves in the opposite direction from
the one in the Installation section.
After the Drum Set Mode procedure, move the lever back to the right so that the
blade is pressing against the drum.
This was covered in the Installation section.
Pressure release
lever: Press this to
move the cleaning
blade into contact or
away from the drum
152
Beluga-C1/C1.5 Training