Ricoh Beluga-C1 Training page 230

Fusing unit: Mark the connectors so that you can
connect them correctly afterwards.
Thermostats: These are not identical. Make sure
that you install and connect them correctly, as
shown in the manual.
There is no adjustment for the pressure springs
after the hot roller or pressure roller is replaced.
Slide 230
Make sure that you are aware of the SP modes that must be done after each
procedure (they are in the procedures in the manual).
FPDB
The diagram is a rear view. So, the right FPDB is on the left side of the drawing
and vice versa.
Thermostats
Make sure that you install them correctly, as shown in the manual.
Fusing Lamps
The fusing lamps are designed so that it is not possible to install the lamps in the
wrong model.
Hot Roller
It is possible to install the roller in the wrong model. The roller for the D049/D155
is heavier.
Replacement and Adjustment
The fusing unit weighs 18 kg (over 40 lb). Be
careful when you lift it.
In some previous models, there is a long screw-
hole that can be used for adjustment.
In this model, the screw-hole is a normal type that
does not allow adjustment.
230
Beluga-C1/C1.5 Training