Ricoh Beluga-C1 Training page 93

Installing the Printer and Scanner Options
The printer and scanner options on SD cards are GW
options.
The printer option consists of two SD cards: Printer SD
card, TIFF/GL Filter
Both of these must be installed in SD card slots. You
cannot move the TIFF/GL module to the printer SD card
(copyright restriction).
Make sure that Ethernet and USB are enabled (SP 5985).
If you want to install the scanner and the printer option,
you must combine the applications onto one SD card and
insert it in Slot 1.
The Memory Unit Type 7140 (D444) is required for Scanner
Option Type W7140 (D397 for
(Note: Scanner Option Type W7140en (D666 for
has built in memory.)
Slide 93
To install the memory option, you must take the controller box cover off. This is a
bit troublesome, so, if you take this cover off for another reason (for example to
install the Gigabit Ethernet or Interface PCB for the Ratio controller), take this
opportunity to install the memory option.
D046/D049 only).
D1546/D155
93
Beluga-C1/C1.5 Training
only)