Setup - Toro Multi Pro 5800-D Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Media and Additional Parts
Description
Starter key
Operator's Manual
Engine owner's manual
Parts Catalog Instruction Card
Screen filter
Note:
Determine the left and right sides of the machine from the normal operating position.
Note:
If you have questions or need additional information regarding the spray control system, refer to the
Operator's Manual supplied with the system.
Important:
This sprayer is sold without spray nozzles.
To use the sprayer, you must obtain and install the nozzles. Contact your authorized Toro distributor for
information on the available section kit and accessories.
After you install your nozzles and before using the sprayer for the first time, adjust the section bypass
valves so that the pressure and application rate remains the same for all sections when you turn 1 or
more sections off. Refer to
Description
Quick-disconnect fitting
No parts required
No parts required
No parts required
Adjusting the Section Bypass Valves (page
Qty.
1
–
–
–
Qty.
2
1
1
Read the manuals before operating the machine.
1
2
12
Use
Assemble the sprayer tank fill fitting.
Check the section-hinge springs.
Check the outer boom cradles.
Remove the shipping bumper.
Use
30).