Replacing The Dvd-Rom/Cdrw Drive; Requirements - Avaya CallPilot 600r Maintenance And Diagnostics

Replacing the DVD-ROM/CDRW drive

Your 600r server comes with a DVD-ROM/CDRW drive installed. The DVD drive is not hot-
swappable. You must power down the system to replace the DVD drive.
You must also remove the server cover and the front bezel to replace the DVD drive.

Requirements

You need a Phillips (cross head) screwdriver, #1 and #2 bits.
To replace the DVD drive
1. Power down the server, unplug all peripheral devices and Ethernet cables, and
2. Remove the server cover. For instructions, see
3. Remove the front bezel. For instructions, see
4. Attach the ESD strap to your wrist and attach the other end to a known grounded
5. At the rear of the DVD-ROM drive, push outward on the cable retention clips on
6. At the rear of the DVD-ROM drive, press inward on the cable retention clip at the
7. Loosen the blue captive screw at the left side of the DVD-ROM drive assembly.
8. Slide the DVD-ROM drive assembly from the chassis.
Avaya CallPilot® 600r Server Maintenance and Diagnostics
Meridian 1 and CallPilot Server Configuration Guide (NN44200-302) for
information about connecting your DS30 cables.
disconnect the AC power.
cover on page 74.
bezel on page 73.
connection.
each side of the DVD-ROM data cable. Releasing the retention clips pushes the
connector from the drive.
right side of the DVD-ROM power cable. While holding the retention clip in, pull the
power cable from the drive.
Note:
There are no cables to disconnect.
Replacing the DVD-ROM/CDRW drive
Removing and replacing the server
Removing and replacing the front
December 2010 85