Requirements - Avaya CallPilot 600r Maintenance And Diagnostics

Caution:
Risk of electrical damage
• Wear an antistatic ESD wrist strap when handling cards or boards, or when working
inside the server.
• Do not touch the components or gold-edged connectors of the cards.
• Place the card on an antistatic surface until you are ready to install it.
The MPB96 card is not hot-swappable and you must power down the system before adding
or replacing the card.

Requirements

• Phillips (cross head) screwdriver, #1 and #2 bits
• Replacement MPB96 card
• Electrostatic Discharge (ESD) grounding strap
There are two versions of MPB96 cards; the NTRH40AA and the NTRH40CA. The following
table provides a comparison of the two cards. If you are replacing an NTRH40AA card with an
NTRH40CA card, make sure your Avaya CS 1000 or Meridian 1 has NTRB18DA MGate cards,
and that you have the correct cables. The NTRH40CA MPB96 does not work with NTRB18CA
MGate cards.
MPB96 version
NTRH40AA
NTRH40CA
To replace the MPB96 card
1. Turn off the server, unplug all peripheral devices and Ethernet cables, unplug the
2. Attach the ESD strap to your wrist and attach the other end to a known grounded
Avaya CallPilot® 600r Server Maintenance and Diagnostics
Description
Has a single DB-44 faceplate
connector
Has three RJ-45 faceplate
connectors
DS30X cable or DS30 cables, and disconnect the AC power.
connection.
Connected to the CS 1000 by
An NTRH2014 DS30X cable.
Up to three standard CAT5e (or
better) RJ-45 connectorized
Ethernet-type DS30 cables
For more information about these
cables, see CS 1000 and Avaya
CallPilot Server Configuration
Guide(NN44200-312) or Meridian 1
and CallPilot Server Configuration
Guide(NN44200-302).
Requirements
December 2010 83