Mitsubishi ECLIPSE CROSS 2017 Owner's Manual page 76

Seat belts
Rear-centre 3-point type seat
belt
The rear-centre 3-point type seat belt must be
worn correctly as illustrated.
4
WARNING
l Be sure to securely connect the both latch
plate (A and B). Failing to do so could sig-
nificantly reduce the amount of protection
and cause serious injures in a collision or
a sudden stop.
To fasten
1. Pull out the buckle (C) from the seat-
back.
Refer to "Rear seat belt storage" on page
4-13.
4-12 Seats and seat belts
2. Pull out the latch plate (A) and then pull
out the small latch plate (B) by tilting it
as shown in the illustration.
E00405201227
3. Pull the seat belt out slowly and pass it
through the seat belt guide (E) so that
the latch plate (A) is turned to the front
side.
OGKE18E1
NOTE
l
When the seat belts cannot be pulled out in a
locked condition, pull the belt once forceful-
ly and then return it.
After that, pull the belt out slowly once
again.
4. Pull the seat belt and insert the small
latch plate (B) into the buckle (C).
5. Insert the latch plate (A) into the buckle
(D).
6. Pull the belt slightly to adjust slackness
as desired.