Mitsubishi ECLIPSE CROSS 2017 Owner's Manual page 233

Refer to "To resume the set speed" on page
6-60.
To deactivate
The set speed driving can be deactivated as
follows:
l
Press the CRUISE CONTROL ON/OFF
switch (A) (Cruise control will be turned
off.)
l Press the "CANCEL" switch (D).
l
Depress the brake pedal.
The set speed driving is deactivated automat-
ically in any of the following ways.
l When you depress the clutch pedal (on
E00609702838
vehicles equipped with M/T).
l When your speed slows to approximate-
ly 15 km/h (10 mph) or more below the
set speed because of a hill, etc.
l When your speed slows to approximate-
ly 30 km/h (20 mph) or less.
l When the Active Stability Control
(ASC) starts operating.
Refer to "Active stability control (ASC)"
on page 6-53.
l
Also, the set speed driving may be deactiva-
ted as follows:
l
l
OGKE18E1
Cruise control
WARNING
On vehicles equipped with CVT, although
the set speed driving will be deactivated
when shifting to the "N" (NEUTRAL) po-
sition, never move the selector lever to the
"N" (NEUTRAL) position while driving.
You would have no engine braking and
could cause a serious accident.
When the engine speed rises and ap-
proaches the tachometer's red zone (the
red-coloured part of the tachometer di-
al).
CAUTION
When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the CRUISE CONTROL ON/OFF
switch to turn off the cruise control and have
your vehicle inspected by a MITSUBISHI
MOTORS Authorized Service Point.
Starting and driving
6
6-59