Mitsubishi ECLIPSE CROSS 2017 Owner's Manual page 167

If the blades are frozen to the windscreen or
rear window, do not operate the wipers until
the ice has melted and the blades are freed,
otherwise the wiper motor may be damaged.
MIST- Misting function
The wipers will operate once.
OFF- Off
AUTO- Auto-wiper control
Rain sensor
The wipers will automatically
operate depending on the degree
of wetness on the windscreen.
LO- Slow
HI- Fast
Rain sensor
Can only be used when the ignition switch or
the operation mode is in ON.
If the lever is put in the "AUTO" position,
the rain sensor (A) will detect the extent of
rain (or snow, other moisture, dust, etc.) and
the wipers will operate automatically.
Keep the lever in the "OFF" position if the
windscreen is dirty and the weather is dry.
Wiper operation under these conditions can
scratch the windscreen and damage the wip-
ers.
CAUTION
l With the ignition switch or the operation
mode in ON and lever in the "AUTO" posi-
tion, the wipers may automatically operate
in the situations described below.
If your hands get trapped, you could suffer
injuries or the wipers could malfunction. Be
sure to turn the ignition switch to the
"LOCK" position or put the operation mode
in OFF, or move lever to the "OFF" position
to deactivate the rain sensor.
OGKE18E1
Wiper and washer switch
CAUTION
• When cleaning the outside surface of the
windscreen, if you touch on top of the
rain sensor.
• When cleaning the outside surface of the
windscreen, if you wipe with a cloth on
top of the rain sensor.
• When using an automatic car wash.
• A physical shock is applied to the wind-
screen or the rain sensor.
NOTE
l To protect the rubber parts of the wipers,
this operation of the wipers does not take
place even if the lever is put in the "AUTO"
position when the vehicle is stationary and
the ambient temperature is approximately 0
°C or lower.
l
Do not cover the sensor by affixing a sticker
or label to the windscreen. Also, do not put
any water-repellent coating on the wind-
screen. The rain sensor would not be able to
detect the extent of rain, and the wipers
might stop working normally.
l In the following cases, the rain sensor may
be malfunctioning.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Au-
thorized Service Point.
• When the wipers operate at a constant in-
terval despite changes in the extent of
rain.
Instruments and controls
5
5-67