Mitsubishi ECLIPSE CROSS 2017 Owner's Manual page 236

Speed Limiter*
To activate
Accelerate or decelerate to your desired
speed, and push down the "SET -" switch
(B). The Speed Limiter memorizes the cur-
rent vehicle speed when you release the "SET
-" switch (B). Now, the Speed Limiter starts
controlling in order not to exceed the set
speed.
6
If the current vehicle speed is lower than ap-
proximately 30 km/h (20 mph) (settable min-
imum speed), the set speed is set at approxi-
mately 30 km/h (20 mph).
The set speed is displayed in the combination
meter.
And, control state "LIMIT" is displayed in
the combination meter.
6-62 Starting and driving
To increase the set speed
E00633601114
By using the RES + switch
Push up the "RES +" switch continuously.
Then the set speed displayed in the combina-
tion meter is gradually increased.
If the set speed reaches your desired speed,
release the "RES +" switch (C).
The set speed is increased each approximate-
ly 5 km/h (3 mph) per approximately 0.5 sec-
ond.
If a driver wants to increase the set speed a
little, push up "RES +" switch for less than
approximately 0.5 second and release it.
The set speed is increased 1 km/h (1 mph)
each taps.
OGKE18E1
By using the CANCEL switch,
the accelerator pedal and the
E00633700017
SET - switch
E00633801116
Press the "CANCEL" switch (D) to deacti-
vate the Speed Limiter.
Control state "LIMIT" is disappeared and
change control state "LIMIT OFF" in the
combination meter.
E00633901117