Mitsubishi ECLIPSE CROSS 2017 Owner's Manual page 358

Troubleshooting
Mode Message
VER ERROR
Other ERROR DC
If You Think Something Is Not Working Properly...
Here is a list of symptoms, causes and responses if you think something is not working properly.
Symptoms
7
There is no sound or quiet
sound.
The disc cannot be inserted. A disc is already in the product.
The disc cannot be played.
The sound skips in the
same place.
There is no sound, even if
the disc is inserted.
7-56 For pleasant driving
Cause
This iPod/iPhone software version is not supported.
An abnormal direct voltage has been sent to the speak-
ers.
Cause
The volume is turned to its minimum.
The balance or fader is turned to one side.
There is no disc in the product, but the product says it is
loading.
The disc is inserted upside down.
The disc has condensation on it.
The disc is dirty.
The disc is damaged or dirty.
Damage to or dirt on the disc means that its data cannot
be read.
Please change to a supported software version.
Turn the power OFF and wait a short while. If the
problem persists, consult a MITSUBISHI MOTORS
Authorized Service Point.
Adjusting the volume.
→ "Adjusting the Volume" on page 7-32.
Adjusting the balance or fader.
→ "Adjust Audio Quality and Volume Balance" on
page 7-50.
Eject the disc.
→ "Insert/Eject Discs" on page 7-32.
Press the eject button once.
→ "Insert/Eject Discs" on page 7-32.
Insert with the label side up.
Wait a while before inserting.
Clean the read surface of the disc.
Check the disc.
Check the disc. Additionally, if using CD-R/RW discs,
their characteristics may render them unable to be
played.
OGKE18E1
Response
Response