Speed Limiter - Mitsubishi ECLIPSE CROSS 2017 Owner's Manual

Speed Limiter*

To resume the set speed
If the set driving speed is deactivated by the
condition described in "To deactivate" on
page 6-59, you can resume the previously set
speed by pushing up the "RES +" switch (C)
while driving at a speed of approximately
30 km/h (20 mph) or higher. The "SET" indi-
cator appears on the information screen of the
6
multi-information display.
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed. In these
situations, repeat the speed setting procedure:
l The CRUISE CONTROL ON/OFF
switch is pressed.
6-60 Starting and driving
l
The ignition switch is turned to the
"LOCK" position or the operation mode
E00609802031
is put in OFF.
l Indication lamp goes off.
Speed Limiter*
The Speed Limiter is a driver assist function
to prevent from exceeding the speed set by
driver while engine power control.
CAUTION
l Because the system does not use service
brake (hydraulic brake), the vehicle speed
may exceed the set speed on the downhill.
If a driver wants to keep the vehicle speed in
such a situation, he/she must put on a service
brake or downshift.
NOTE
l If the clutch pedal (M/T) is depressed, the
Speed Limiter does not activate.
If the vehicle speed exceeds the set speed
(approximately 3 km/h (2 mph)), the indica-
tor will blink in the combination meter.
If the vehicle speed exceeds the set speed ap-
proximately +3 km/h (+2 mph) more than ap-
proximately 5 seconds after indicated alert
message, beep alert is sounded for approxi-
mately 10 seconds at the most.
OGKE18E1
While running without alert message, if you
decrease the set speed and vehicle speed is
more than set speed approximately +3 km/h
(+2 mph), alert message is displayed but beep
alert is delayed.
In this case, when vehicle speed keeps ex-
ceeding set speed approximately +3 km/h
E00633201136 (2 mph) for approximately 30 seconds after
the alert message is appeared, beep alert is
sounded for approximately 10 seconds at the
most.
If the vehicle speeds decreases less than set
speeds after the alert message is appeared,
the message is disappeared. When beep alert
is sounding, the beep alert also goes off.
NOTE
l
However, this gives priority to audio and
visual signal of safety reasons or driver's de-
mand.
l If the set speed is too lower based on current
shift position, the Speed Limiter may not
limit the vehicle speed to prevent engine
stall.