Mitsubishi ECLIPSE CROSS 2017 Owner's Manual page 272

Blind Spot Warning (BSW) (with Lane Change Assist)*
NOTE
l
The Blind Spot Warning lamp in the outside
rear-view mirror may come on or blink in
the following conditions.
• When driving very near the guardrail or a
concrete wall.
• When driving on the entrance and outlet
of a tunnel or very near to the wall or near
the evacuation area inside a tunnel.
6 • When turning an intersection in a town
area.
• Under adverse weather conditions (rain,
snow, sand stream etc.).
• When you drive your vehicle with blow-
ing up the water, snow or sand etc. on the
road.
• When driving near a kerb, pothole and
tramline.
l Set the BSW to OFF when towing.
l The Blind Spot Warning lamp in the outside
rear-view mirror may appear not to be on
due to strong direct sunlight or the glare
from the headlamps of vehicles behind you
during night driving.
System problem warning
If a problem occurs with the system, a visual
warning specific to the type of the problem is
given together with an audible alarm.
The warnings are combined with the Rear
Cross Traffic Alert (RCTA) system.
6-98 Starting and driving
When there is a malfunction in
the system or the sensor
When the warning display appears, the BSW
does not operate normally because there are
some malfunctions in the system or the sen-
sor. Have the vehicle inspected at a
MITSUBISHI MOTORS Authorized Service
Point as soon as possible.
NOTE
l When the warning display appears, the BSW
will be deactivated.
When the sensor is temporarily
not available
E00692500029
OGKE18E1
When the warning display appears, the sensor
is temporarily not available for some reason
such as the environmental condition or in-
E00692600033
crease of the sensor temperature. When the
warning display does not disappear after
waiting for a while, contact a MITSUBISHI
MOTORS Authorized Service Point.
When there are foreign objects
on the sensor
When the warning display appears, the sensor
cannot detect a vehicle travelling side by side
or an approaching vehicle, because foreign
objects, such as dirt, snow or ice, adhere to
the bumper surface around the sensor.
Remove dirt, freezing or foreign material on
the bumper surface around the sensor.
When the warning display does not disappear
E00692700034
after having cleaned the sensor, contact a
MITSUBISHI MOTORS Authorized Service
Point.
E00692800048